Short Range Install Guide

STEP 1: Unscrew the green cap counterclockwise to remove it from the nozzle.

STEP 2: Insert the short range insert into the bottom of the nozzle, with the arrow pointing towards the spray ports.

Orientation matters. The stamped arrow must point towards the spray ports of the nozzle.

STEP 3: Place the screen mesh filter back on top of the restrictor.

STEP 4: Insert the full assembly into the riser and twist the nozzle cap clockwise firmly onto the riser.

A confirmation screen will pop up showing how the Short Range Insert should be installed. If it is installed correctly, proceed.

Calibration will automatically retry up to 3 times before it fails if it detects insufficient water pressure/flow, air bubbles, or debris. If the calibration continues to fail, please contact us for support.

Now that the calibration is complete, the head needs to be assigned a perimeter. To map that perimeter, select "Edit Shape". Once in the mapping tool, add points & move them to where they're needed until your desired perimeter is complete. Use the "Play" function to see how the head will operate during future quick runs.

Short Range Heads can map distances between 1' and 15' away. If a point is moved too close to the head, an error message will appear at the top of the screen. Points will not be able to be placed further than 15' away.