The demo stand runs off a standard garden hose — no mainline tap or trenching needed for the demo.

• Wrap Teflon tape on the stand's hose fitting before connecting to the hose

• Wrap Teflon tape on the Sprinkler 3 inlet before threading the head onto the stand

• Hand-tighten both connections. Don't overtighten.

• Turn the hose on and verify no leaks at either connection before moving on

The Smart Controller 3 runs off a standard outlet. Setup is app-based and takes a few minutes.

• Plug the controller into any standard outlet

• Open the Irrigreen app and log in or create an account

• Accept all permissions when prompted (location, camera, network, and Bluetooth are all required)

• Follow the on-screen prompts to connect to Wi-Fi

• Controller will prompt an update on first connect. Let it finish before touching anything else

If you are using a mobile hotspot network, a different phone must be used to connect for app access

Standard daisy-chain wiring. Same rules apply here as a full install.

• Plug the red cable into terminal i1 on the controller and black into (C) common

• MALE (small) connectors always point BACK toward the controller

• FEMALE (large) connectors always point AWAY from the controller

With everything wired up, finish the setup in the app.

• Go to Zones → "+" → "Add Irrigreen Sprinkler"

• Stand near the head with Bluetooth on. App will identify and then you can assign it.

• When prompted to calibrate, skip it. Hose supply pressure won't support a full calibration sequence.

• Go to Zones → select zone → "Edit Shape"

• Map the zone shape to your demo area. Points can be adjusted in 6-inch increments or dragged on screen.

• Hit Play to run a quick preview of the spray pattern

• Go to Schedules → "+" to set a run time

Kit is live and ready to demo!