Skip to Content
Sprinkler 2Cleaning an Irrigreen Filter

Clean a Filter

Try this solution

Cleaning an Irrigreen Filter

Removing Cap for Servicing Nozzle and Filter

  • Lift riser up

  • Grasp riser and remove cap by hand

  • Tighten torx screw on cap after reassembly to mitigate leak at the screw

Clogged filter can cause shortened stream distances or uneven spacing

  • Remove cap as shown and clean filter (depending on your version, filter may be flat or conical) and or nozzle

  • Place filter back inside neck riser (see below for conical filters).

  • Hand tighten cap back onto riser until snug.

For conical filters (pre-2023 sprinkler heads), align the two white lines with the opening of the neck riser.

Powered by MavenoidSitemap
ProductGet QuoteInstallersWarrantyLogin
About UsInvestorsPrivacy PolicyTerms of Service