Skip to Content
Sprinkler 2ErrorsTimeout Error

Timeout Error

Timeout Error

Communication between the sprinkler and the controller is failing. You may be able to find the head in a line scan but it is unresponsive to your commands (calibration, mapping, schedules).

Top Causes

● Head did not check into controller properly/receive update. Power cycle by pressing green button.
● Sprinkler is numbered incorrectly or conflicting with another numbered head.
● e.g., controller is looking for #2, but there is no #2 responding, or there are two #2s on the line.
● Sprinkler cable connection is loose or obstructed near the head. Check connection, reconnect if necessary.
● Overlapping schedules on older software may have attempted to power too many sprinklers at once.

A good start to fix this issue, especially with newer installs, is to power cycle the system. With no schedules on, unplug the controller from the wall outlet, allow to sit for 1 hour, plug in controller, allow 1 minute for it to come back online and then reset the controller with the green reset button. After a minute, attempt the boot up the head and see if it is working.

If that does not work, run a test and detect and see if you can find the head. If you see it assigned to a Zone, attempt to start up. If you see heads, but they aren't assigned to Zones, you can go ahead and assign the heads to their respective Zones. If you don't see all or some of your Zones, check your wiring connections in, out, and between those heads for loose plugs.

Powered by MavenoidSitemap
ProductGet QuoteInstallersWarrantyLogin
About UsInvestorsPrivacy PolicyTerms of Service